Layout Plan equipment

FLAG POLE GREEN AREA GREEN AREA R O A D EP EP 1 5 10 12 13 15 送風恒温乾燥機 上皿天秤 ｐH測定器 精密天秤 B型粘度計 恒温槽 恒温水槽 純水装置 ガードナー ハーゼン 恒温槽 恒温槽 ドラフトチャンバー 冷蔵庫 薬品庫 薬品庫 洗面台 作業台 器具保管庫 器具乾燥機 廃液保管庫 書庫 ﾊﾛｹﾞﾝ ｽﾀｰﾗｰ 屈折率計 デスク デスク ６０℃ ５℃&４５℃ ２５℃ BOP6,300mm BOP6,300mm BOP6,300mm BOP6,300mm Compressor Buffer Tank Vacuum Pump Salt Water Tank BW TANK BW PUMP Receiver Tank Recycled water drainage (gutter) Drainage(gutter) BOP1,000mm BOP1,500mm BOP2,500mm BOP5,000mm BOP500mm BOP500mm BOP500mm BOP5,000mm BOP500mm BOP0mm BOP2,500mm SCR switch VAC switch BW Switch Water Softener EP R O A D GREEN AREA GREEN AREA GREEN AREA LEGEND : : BM = PL+6.140 (PL±00) = ACTUAL GROUND LEVEL FL±0.00 = PL+6.953 GREEN GREEN COVER DRAIN GREEN GREEN COVER DRAIN PL+6.273 PL+6.289 PL+6.361 PL+6.382 PL+6.354 PL+6.421 PL+6.348 PL+6.272 PL+6.339 PL+6.342 ELECTRIC POLE PL+6.374 (PL+6.373) (PL+6.873) 3% (PL+6.953) BENCH MARK (PL+6.140) GUARD HOUSE 23.10m² PL+6.433 PL+6.438 PL+6.435 LEGEND : (PL+6.410) N Lot No. C6, Bangladesh Special Economic Zone (BSEZ), Sonpara, Panchrukhi Via Rupganj Araihazar Narayanganj-1460 Bangladesh Tel: +880255033391 18 Production Process: Process 1: The vacuum pump is used to create a vacuum inside the vessel. This is done by removing the air from the vessel. Once the vessel is under vacuum, the raw materials can be drawn into the vessel. Process 2: The raw material A and B are injected into the vessel through the raw material charging nozzle. The raw material A and B are typically a liquid. It is important to note that the raw material A and B are NON-DG, which means that it is not a dangerous good. Process 3: Agitate and mix the raw materials to combine at room temp. Process 4: Insert raw material C (NON-DG) from sampling nozzle. The raw material C is typically a liquid. Process 5: Agitate and mix the raw materials to combine at room temp. Process 6: Soft water is added to the vessel through a counter. The soft water is typically at room temperature. Process 7: Agitate and mix the raw materials to combine at room temp. Process 8: Sampling from sampling nozzles for midterm inspection. Process 9: The vessel is pressurized using a compressor. This pressure is needed to fill the drums with the finished product. The pressure inside the vessel forces the product into the drums. Once the drums are filled, the product is ready to be shipped to customers.